Factory specification
Layout, dimensions and factory hardware, each with its source.
Facts tagged “Researched, unverified” come from our engine catalog without a cited source yet.
N55 horsepower and torque
Ratings as the manufacturer published them, with their basis. They are not GAINS measurements or tuning results.
- 235 kW @4505-6000, 450 Nm @1300-4500315 hp
- 240 kW322 hp
- 250 kW N55HP335 hp
- 265 kW @5255-6000, 465 Nm @1350-5250355 hp
- 272 kW @6500, 500 Nm @1450-4750 (M2 2016-18)365 hp
- Alpina 301/324/332 kW
N55 firing order
N55 injectors
The factory injector, then direct-fit upgrades the makers list for this engine.
Factory injector
Direct-fit upgrades
Sets the maker lists for this engine. Fit is the maker’s own statement; flow is the maker’s rating and test basis.
| Injector | Flow | Fit |
|---|---|---|
| Bosch (OEM S63TU EU5 injector) Bosch 0 261 500 136 DI injector · 0261500136Low7 | not stated retailer: ~33% more flow than standard N55/S55 injector | Needs adapter ISTA-P injector coding; check EU5/EU6 rail compatibility |
| Nostrum Nostrum Stage 2 DI injectors (N55/S55) · H703-1257Medium6 | not stated 17.0 g/s at 100 bar (maker; stock 10.9 g/s) | Plug-in |
| Nostrum Nostrum Stage 3 DI injectors (N55/S55) · H750-1605Medium6 | not stated 20.2 g/s at 100 bar (maker) | Plug-in |
Sensors
Factory sensors by role: part numbers, signal type and fitment years.
| Sensor | OEM part numbers | Type / signal | Years and markets |
|---|---|---|---|
| Cam position × 2 | BMW 13627525014Sourced · medium9 | Hall effect · digital | |
| Knock | BMW 13627566786Sourced · medium89 | piezo knock sensor | N55 E/F series |
| MAP | BMW 13627585493 (early N55) | 13627599042 (later N55, after 8/2010)Sourced · medium810 | boost pressure-temperature sensor (TMAP) · 0-5 V analog | Year split around 3/2011 (E9x, F10) and 9/2010 (X5)Location: intake manifold or charge pipe depending on car |
| MAF × 1 | Not yet sourcedSourced8 | hot-film air mass meter (HFM) | Shown in N55 intake diagram |
| O2 (upstream) × 1 | Not yet sourcedSourced · medium8 | oxygen sensor upstream of catalytic converter | Single twin-scroll turbo; type not stated |
| O2 (downstream) × 1 | Not yet sourcedSourced · medium8 | oxygen sensor after ceramic structure 1 | |
| Coolant temp × 1 | Not yet sourcedSourced8 | coolant temperature sensor |
Ignition and triggers
Tuning notes
Factory load sensing
The factory ECU measures load by MAF+MAP (blended / torque model). BMW ST916: MEVD17.2 with Siemens SIMAF GT2 HFM plus intake-manifold pressure sensor after throttle and charge air temp/pressure sensor; LSU ADV pre-cat. Whether later F-chassis N55 deleted the HFM was NOT verified.32
Factory oxygen sensors
Upstream: wideband A/F (Bosch LSU ADV) (1). Downstream O2 sensors: yes. Closed-loop fuelling: wideband control sensor before cat; post-cat monitor sensor.32
Driver and calibration
Low-impedance and direct injectors need a peak-and-hold or direct-injection driver. Any injector change also needs new flow and dead-time data in the calibration. Researched, unverified
Known limits (reported)
Stock rods, bearings and pistons are commonly named as first failures, with pre-detonation a major cause; cast crank on base N55 differs from S55/T0 forged crank. Crank-hub slip is widely discussed (vendor claims).Medium451
Common first upgrades (reported)
Builders most often report upgrading: crank hub, fuel system, then rods.Medium451
Valvetrain, factory engine management and weak points across every generation are on the BMW N54 guide.
Vehicles with the N55 3.0 T
Sources
Numbered as cited above. Hover or tap a citation chip to preview it.
10 sources
- Factory ratings: BMW N5x (N54/N55) (E-755) · en.wikipedia.org · reference · retrieved 2026-10-25
- BMW DME by engine (E-861) · archive.org · service-manual · retrieved 2026-10-25
- BMW N55 (E-866) · archive.org · service-manual · retrieved 2026-10-25
- BMW N55 internals (E-1061) · archive.org · service-manual · retrieved 2026-10-25
- BMW S55 internals (E-1062) · archive.org · service-manual · retrieved 2026-10-25
- Nostrum N55/S55 Stage 2/3 DI injectors (E-1267) · hackengineering.co.uk · reference · retrieved 2026-10-25
- BMW N55/S55 OEM variants and S63TU upgrade injector (E-1273) · hackengineering.co.uk · reference · retrieved 2026-10-25
- Sensors (E-1384) · archive.org · service-manual · retrieved 2026-10-25
- Part numbers (E-1387) · fcpeuro.com · reference · retrieved 2026-10-25
- Part numbers (E-1388) · bimmerworld.com · vendor-doc · retrieved 2026-10-25
Evidence ids (E-…) refer to our research register; each records the source, date and confidence.

