Factory specification
Layout, dimensions and factory hardware, each with its source.
Facts tagged “Researched, unverified” come from our engine catalog without a cited source yet.
SR20DET horsepower and torque
Ratings as the manufacturer published them, with their basis. They are not GAINS measurements or tuning results.
- S13 Silvia/180SX: 205 PS @6000, 275 Nm @4000, CR 8.51991-93 red top
- S14 Silvia (black top 1993-98): 220 PS @6000, 275 Nm @4800, CR 8.5
- S15 Spec-R auto: 225 PS @6000, 28.0 kgm @4800
- Pulsar GTI-R (RNN14): 230 PS @6400, 280 Nm @4800, CR 8.3
- U12 Bluebird 1989: 205 PS
- Wikipedia table gives stock boost ~7 psi (S13/S14/S15) and 10.6 psi GTI-R (uncited, not OEM)
SR20DET firing order
SR20DET injectors
The factory injector, then direct-fit upgrades the makers list for this engine.
Factory injector
Direct-fit upgrades
Sets the maker lists for this engine. Fit is the maker’s own statement; flow is the maker’s rating and test basis.
| Injector | Flow | Fit |
|---|---|---|
| DeatschWerks G20/SR20/240sx SR20DET/KA24DE 550cc (side feed, 91-98) · 01J-00-0550-418 | 550 cc/min maker listing (pressure basis not stated on product page) | Plug-in |
| DeatschWerks G20/SR20/240sx SR20DET/KA24DE 740cc (side feed, 91-98) · 01J-00-0740-417 | 740 cc/min maker listing (pressure basis not stated on product page) | Plug-in |
| DeatschWerks G20/SR20/240sx SR20DET/KA24DE 950cc (side feed, 91-98) · 02J-01-0950-416 | 950 cc/min maker listing (pressure basis not stated on product page) | Plug-in |
| Fuel Injector Clinic Nissan 240SX 14mm Setup (High-Z) · IS182-1000HMedium19 | 1000 cc/min 3.0 bar (43.5 psi), CF-16B calibration fluid, 90 F (maker spec) | Needs adapter top-feed 14mm rail setup (FIC "Setup" sets are for top-feed rails; OEM side-feed) + solder-in USCAR pigtails |
| Injector Dynamics ID1050-XDS (240SX-S13/S14/S15 14mm) · 1050.60.14.14.4Medium46810 | 1065 cc/min 3.0 bar (43.5 psi), gasoline, 52 C (maker spec) | Needs adapter aftermarket top-feed fuel rail (OEM rail is side-feed) + USCAR plug adapter |
| Injector Dynamics ID1300-XDS (240SX-S13/S14/S15 14mm) · 1300.60.14.14.4Medium57911 | 1335 cc/min 3.0 bar (43.5 psi), iso-octane, 52 C (maker spec) | Needs adapter aftermarket top-feed fuel rail (OEM rail is side-feed) + USCAR plug adapter |
Sensors
Factory sensors by role: part numbers, signal type and fitment years.
| Sensor | OEM part numbers | Type / signal | Years and markets |
|---|---|---|---|
| Crank position × 1 | Not yet sourcedCross-ref: AEM 30-8760 replacement 50 mm disk (RWD)Sourced · medium14 | optical crank angle sensor (CAS) on exhaust cam, also serves cam role · RWD disk 50 mm; some FWD 54 mm · digital (optical) | S13/S14/S15 RWDCombined crank/cam on cam drive; RWD vs FWD disk size differs per seller |
| Cam position | Not yet sourcedResearched, unverified | combined with CAS (see crank) | Single optical CAS gives both signals |
| Knock × 1 | 22060-30P00Low confidence14 | piezo knock sensor | S13/S14/S15 (seller listings)Number shared with KA24DE/VG30/other Nissans in seller listings; not confirmed in Nissan catalogue |
| MAP | Not yet sourcedResearched, unverified | Not yet sourced | No factory MAP used for fuelling found (MAF-based); boost-pressure sensor fitment not confirmed |
| MAF × 1 | Not yet sourcedResearched, unverified | hot-wire, analog 0-5 V · 0-5 V analog | MAF type per Nissan family practice; OEM number differs by S13/S14/S15 and not sourced |
| O2 (upstream) × 1 | Not yet sourcedResearched, unverified | narrowband zirconia · 0-1 V | Narrowband only; heater/wire count varies by chassis and not sourced |
| Coolant temp × 1 | Not yet sourcedResearched, unverified | NTC thermistor · 0-5 V analog | |
| Throttle position × 1 | Not yet sourcedResearched, unverified | potentiometer with idle switch · 0-5 V analog | Cable throttle |
Ignition and triggers
- Optical crank angle sensor (CAS) on exhaust cam, also serves cam role, RWD disk 50 mm
- Some FWD 54 mm, digitaloptical
Tuning notes
Factory load sensing
The factory ECU measures load by MAF (hot-wire / hot-film). No SR20DET-specific OEM doc read (S14 SR20DET FSM mirror file corrupt); values inferred from same-era Nissan ECCS FSMs (S13/S14 KA24DE, B14 SR20DE: hot-film/hot-wire MAF, single front O2). JDM cars no rear O2.Low2
Factory oxygen sensors
Upstream: narrowband (zirconia) (1). Downstream O2 sensors: varies. Closed-loop fuelling: narrowband closed loop at idle/cruise only, open loop under load/WOT (inferred from Nissan ECCS FSM text for SR20DE/KA24DE).Low2
Injector drive
Factory injector impedance: high (saturated). Connector: JECS Nissan side-feed (DW "Jecs").Low131210
Driver and calibration
High-impedance injectors run from a saturated driver. Any injector change needs new flow and dead-time data in the calibration. Researched, unverified
Known limits (reported)
MotoIQ cites rod-bearing oil starvation, finger-follower rockers flying off on over-rev, and water pump cavitation near 6,600 rpm; ring lands of stock pistons commonly reported as the first combustion-side failure (shop/forum).Medium315
Common first upgrades (reported)
Builders most often report upgrading: ARP head studs + MLS gasket, forged pistons/rods, wider GTI-R bearings and higher-capacity VE/GTI-R oil pump, valvetrain (mechanical lash) (MotoIQ, Brewed Motorsports).Medium315
Valvetrain, factory engine management and weak points across every generation are on the Nissan SR20 guide.
Vehicles with the SR20DET (red / black top, S15)
Sources
Numbered as cited above. Hover or tap a citation chip to preview it.
19 sources
- Factory ratings: Nissan SR family (SR20DET/DE/VE) (E-733) · 221616.com · reference · retrieved 2026-10-25
- Nissan SR/KA ECCS fueling (E-840) · servicemanuals-backend.fly.storage.tigris.dev · service-manual · retrieved 2026-10-25
- Nissan SR20 internals (E-1090) · en.wikipedia.org · reference · retrieved 2026-10-25
- Injector aftermarket fitment (E-1200) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
- Injector aftermarket fitment (E-1201) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
- Injectors / ID1050-XDS fitment (E-1230) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
- Injectors / ID1300-XDS fitment (E-1231) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
- Injector Dynamics ID1050-XDS fitment table (E-1260) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
- Injector Dynamics ID1300/ID1750/ID2600 fitment tables (E-1261) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
- Injector Dynamics ID1050-XDS fitment table (E-1290) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
- Injector Dynamics ID1300-XDS fitment table (E-1291) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
- DeatschWerks injector catalogue (E-1294) · deatschwerks.com · vendor-doc · retrieved 2026-10-25
- SR20DET OEM injectors (E-1299) · sr20forum.nfshost.com · community · retrieved 2026-10-25
- Sensors/Nissan knock 22060-30P00 and SR CAS (E-1418) · walmart.com · reference · retrieved 2026-10-25
- OEM turbo: nissan-sr20det-t28 (E-10096) · en.wikipedia.org · reference · retrieved 2026-11-04
- deatschwerks.com product listing · deatschwerks.com · vendor-doc · retrieved 2026-10-25
- deatschwerks.com product listing · deatschwerks.com · vendor-doc · retrieved 2026-10-25
- deatschwerks.com product listing · deatschwerks.com · vendor-doc · retrieved 2026-10-25
- fuelinjectorclinic.com product listing · fuelinjectorclinic.com · vendor-doc · retrieved 2026-10-25
Evidence ids (E-…) refer to our research register; each records the source, date and confidence.

