Factory specification
Layout, dimensions and factory hardware, each with its source.
Facts tagged “Researched, unverified” come from our engine catalog without a cited source yet.
K20A2 horsepower and torque
Ratings as the manufacturer published them, with their basis. They are not GAINS measurements or tuning results.
- EP3 EDM Civic Type R (K20A2): 200 hp @7400, 139 lb-ft @5900, redline 7900188 Nm
- AUDM/NZDM Integra Type R: 200 hp @7400, 142 lb-ft @6000, redline 7800
K20A2 firing order
K20A2 injectors
The factory injector, then direct-fit upgrades the makers list for this engine.
Factory injector
Direct-fit upgrades
Sets the maker lists for this engine. Fit is the maker’s own statement; flow is the maker’s rating and test basis.
| Injector | Flow | Fit |
|---|---|---|
| DeatschWerks DW 550cc matched set · 17U-08-0550-419 | 550 cc/min maker rating (basis not stated on page) | Needs adapter USCAR-to-OEM plug adapter (DW page states USCAR connector; adapter inclusion not stated) |
| DeatschWerks DW 1500cc matched set · 16M-03-1500-420 | 1500 cc/min maker rating (basis not stated on page) | Needs adapter USCAR-to-OEM plug adapter (DW page states USCAR connector; adapter inclusion not stated) |
| Fuel Injector Clinic FIC 445cc High-Z set · is116-0445h21 | 445 cc/min at 43.5 psi (3 bar), CF-16B fluid 90 F (maker) | Needs adapter USCAR-to-Honda OBD2 plug adapters PADPUtoH4 (optional) or solder-in pigtails PGTUSC4 (included) |
| Fuel Injector Clinic FIC 1000cc High-Z set · is116-1000h18 | 1000 cc/min at 43.5 psi (3 bar), CF-16B fluid 90 F (maker) | Needs adapter USCAR-to-Honda OBD2 plug adapters PADPUtoH4 (optional) or solder-in pigtails PGTUSC4 (included) |
| Injector Dynamics ID1050-XDS · 1050.48.14.14.4571113 | 1065 cc/min at 3.0 bar, gasoline 52 C (maker) | Needs adapter USCAR-to-Honda OBD2/K-series plug adapters (ID connector is USCAR; adapters sold separately per retailer listings E-1238) |
| Injector Dynamics ID1300-XDS · 1300.48.14.14.4681214 | 1335 cc/min at 3.0 bar, iso-octane 52 C (maker) | Needs adapter USCAR-to-Honda OBD2/K-series plug adapters (ID connector is USCAR; adapters sold separately per retailer listings E-1238) |
K20A2 swap
Swap guides that recommend this engine or its family. Each guide covers mounts, transmission, fuel, wiring, tuning and the law, with sources.
Sensors
Factory sensors by role: part numbers, signal type and fitment years.
| Sensor | OEM part numbers | Type / signal | Years and markets |
|---|---|---|---|
| Knock | Honda 30530-PRB-A01Sourced1617 | knock sensor | US RSX Type-S 2002-2006 (KA 6MT); retailer also lists EP3 Civic Type R and DC5 Integra Type R |
| MAP | Honda 37830-PGK-A01Sourced · medium1615 | MAP sensor ('Sensor Assembly, MAP') | US 2003 RSX2005-06 RSX listed by retailer with 37830-PNC-003. |
| MAF | Not yet sourcedSourced · medium16 | none listed in OEM catalogue (speed-density, MAP-based) | |
| O2 (upstream) | Honda 36531-PRB-A01Sourced · medium16 | wideband air-fuel ratio sensor (Honda 'Sensor, Air Fuel Ratio') | US 2003 RSX (PRB = Type-S code family)PRB/PND split by trim inferred from the PRB-coded knock sensor fitment (Type-S only). |
| O2 (downstream) | Honda 36532-PRB-A01Sourced · medium16 | oxygen sensor (middle/secondary) | US 2003 RSX Type-S |
Ignition and triggers
Tuning notes
Factory load sensing
The factory ECU measures load by MAP speed-density. 2002 RSX press: PGM-FI monitors intake-manifold pressure and exhaust O2 (no MAF named). Upstream A/F sensor sourced only to a parts guide (low). EU EP3 Type R not checked separately.Medium12
Factory oxygen sensors
Upstream: wideband A/F (Honda/Denso A/F ratio sensor, 4-wire) upstream (1). Downstream O2 sensors: yes. Closed-loop fuelling: A/F-sensor closed loop at part load; open loop enrichment at high load/WOT.Medium12
Injector drive
Factory injector impedance: high (saturated). Connector: Honda OBD2 / K-series.Medium9107
Driver and calibration
High-impedance injectors run from a saturated driver. Any injector change needs new flow and dead-time data in the calibration. Researched, unverified
Known limits (reported)
Stock rods and especially rod bolts are commonly reported as the first bottom-end limit under boost (vendor and forum consensus); some builders also add sleeves or a block guard because the block is open-deck (single forum opinion).Low34
Common first upgrades (reported)
Builders most often report upgrading: forged rods with upgraded bolts (vendor/forum).Low34
Valvetrain, factory engine management and weak points across every generation are on the Honda K-series guide.
Vehicles with the K20A2 (RSX Type S / EP3 EU Type R)
Sources
Numbered as cited above. Hover or tap a citation chip to preview it.
21 sources
- Honda K20A2/A3 load sensing (E-824) · acuranews.com · oem · retrieved 2026-10-25
- Honda K20A A/F sensor (E-825) · go-parts.com · vendor-doc · retrieved 2026-10-25
- Honda K-series internals (E-1035) · en.wikipedia.org · reference · retrieved 2026-10-25
- Honda K-series limits (E-1036) · hybrid-racing.com · vendor-doc · retrieved 2026-10-25
- Injector aftermarket fitment (E-1200) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
- Injector aftermarket fitment (E-1201) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
- Injectors / ID1050-XDS fitment (E-1230) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
- Injectors / ID1300-XDS fitment (E-1231) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
- Injectors / K-series stock flow (E-1240) · hybrid-racing.com · vendor-doc · retrieved 2026-10-25
- Injectors / K-series OEM PNs (E-1242) · fridayparts.com · vendor-doc · retrieved 2026-10-25
- Injector Dynamics ID1050-XDS fitment table (E-1260) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
- Injector Dynamics ID1300/ID1750/ID2600 fitment tables (E-1261) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
- Injector Dynamics ID1050-XDS fitment table (E-1290) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
- Injector Dynamics ID1300-XDS fitment table (E-1291) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
- OEM sensor PNs (Honda) (E-1350) · hondapartsnow.com · vendor-doc · retrieved 2026-10-25
- OEM sensor PNs (Acura RSX/TSX) (E-1353) · acurapartswarehouse.com · reference · retrieved 2026-10-25
- JDM K20A knock sensor (E-1362) · hybrid-racing.com · vendor-doc · retrieved 2026-10-25
- fuelinjectorclinic.com product listing · fuelinjectorclinic.com · vendor-doc · retrieved 2026-10-25
- deatschwerks.com product listing · deatschwerks.com · vendor-doc · retrieved 2026-10-25
- deatschwerks.com product listing · deatschwerks.com · vendor-doc · retrieved 2026-10-25
- fuelinjectorclinic.com product listing · fuelinjectorclinic.com · vendor-doc · retrieved 2026-10-25
Evidence ids (E-…) refer to our research register; each records the source, date and confidence.



